Troubleshooting v2.0 drivers - pchdtv.com

pchdtv.com :: View topic - installed 2.0 drivers on 2.6.9 got no sig level on dtvsignal: "How about posting lines of relevtive lines from syslogd starting from the 'Linux video capture interface: v1.00' and down. Hint: The devices that the kernel assigns are in these messages. Also, VEEEERY important, make sure the tv signals are getting to the card.

Also, just do 'modprobe cx88_atsc' will be enuff."

lsmod output (see post).

dmesg:
"Linux video capture interface: v1.00
cx2388x v4l2 driver version 0.0.4 loaded
ACPI: PCI Interrupt Link [LNK2] enabled at IRQ 3
ACPI: PCI interrupt 0000:01:09.0[A] -> GSI 3 (level, low) -> IRQ 3
cx88[0]: subsystem: 7063:3000, board: pcHDTV HD3000 HDTV [card=22,autodetected]
tuner 2-0061: chip found @ 0xc2 (cx88[0])
tuner 2-0061: type set to 52 (Thomson DDT 7610 (ATSC/NTSC))
cx88[0]/0: found at 0000:01:09.0, rev: 5, irq: 3, latency: 32, mmio: 0xe2000000
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
cx88[0]/0: registered device radio0
pcHDTV HD3000 driver version 2.0.0 loaded
ACPI: PCI interrupt 0000:01:09.2[A] -> GSI 3 (level, low) -> IRQ 3
cx88[0]/2: found at 0000:01:09.2, rev: 5, irq: 3, latency: 32, mmio: 0xe3000000
cx88[0]/2 FW version: 113-4-194-3
cx88[0]/2: registered device video1 [atsc]"

"registered device video1 [atsc]" = /dev/video1 (type=atsc)